H3C Technologies H3C SecPath F1000-E - Manual (Page 13)

12
Configuration procedure
NOTE:
Before the configuration, make sure that Device A and Device B are reachable to each other.
Step1 Configure Device A
<DeviceA> system-view
# Enable IPv6.
[DeviceA] ipv6
# Configure an IPv4 address for interface GigabitEthernet 1/1.
[DeviceA] interface gigabitethernet 1/1
[DeviceA-GigabitEthernet1/1] ip address 10.1.1.1 255.255.255.0
[DeviceA-GigabitEthernet1/1] quit
# Configure an IPv6 address for interface GigabitEthernet 2/0, the physical interface of the tunnel.
[DeviceA] interface gigabitethernet 2/0
[DeviceA-GigabitEthernet2/0] ipv6 address 2002::1:1 64
[DeviceA-GigabitEthernet2/0] quit
# Create an interface named Tunnel 0.
[DeviceA] interface tunnel 0
# Configure an IPv4 address for interface Tunnel 0.
[DeviceA-Tunnel0] ip address 10.1.2.1 255.255.255.0
# Configure the tunnel encapsulation mode as GRE over IPv6.
[DeviceA-Tunnel0] tunnel-protocol gre ipv6
# Configure the source address of interface Tunnel 0 to be the IP address of interface GigabitEthernet
2/0.
[DeviceA-Tunnel0] source 2002::1:1
# Configure the destination address of interface Tunnel 0 to be the IP address of interface
GigabitEthernet 2/1 on Device B).
[DeviceA-Tunnel0] destination 2002::2:1
[DeviceA-Tunnel0] quit
# Configure a static route from Device A through interface Tunnel 0 to Group 2.
[DeviceA] ip route-static 10.1.3.0 255.255.255.0 tunnel 0
Step2 Configure Device B
<DeviceB> system-view
# Enable IPv6.
[DeviceB] ipv6
# Configure an IPv4 address for interface GigabitEthernet 1/1.
[DeviceB] interface gigabitethernet 1/1
[DeviceB-GigabitEthernet1/1] ip address 10.1.3.1 255.255.255.0
[DeviceB-GigabitEthernet1/1] quit
# Configure an IPv6 address for interface GigabitEthernet 2/1, the physical interface of the tunnel).
[DeviceB] interface gigabitethernet 2/1
[DeviceB-GigabitEthernet2/1] ipv6 address 2002::2:1 64