H3C Technologies H3C SecPath F1000-E - Manual (Page 55)

22
Configuration Example for LAC-Auto-Initiated VPN
Network requirements
Create a virtual PPP user on the LAC and configure the LAC to initiate a tunneling request to the LNS to
establish an L2TP tunnel for the virtual PPP user. When a VPN user accesses the corporate network, all
packets between the VPN user and the corporate network are transmitted through the L2TP tunnel. A
VPN user accesses the corporate network as follows:
1. The VPN user sends a packet to the LAC through the LAN.
2. The LAC encapsulates the packet and then forwards the packet through the L2TP tunnel to the LNS.
Figure 11 Network diagram for the LAC-auto-initiated VPN
Internet
LAC VPN user LNS
L2TP tunnel
LAN
10.2.0.0/16
GE1/1
3.3.3.2/24
GE1/1
3.3.3.1/24
Corporate
10.1.0.0/16
10.2.0.1 10.1.0.1
Configuraton procedure
Step1 Configure the LNS
# Configure IP addresses for interfaces. (Omitted)
# Create a local user, configure a username and password for the user, and specify the service type as
PPP.
<LNS> system-view
[LNS] local-user vpdnuser
[LNS-luser-vpdnuser] password simple Hello
[LNS-luser-vpdnuser] service-type ppp
[LNS-luser-vpdnuser] quit
# Configure a virtual template interface.
[LNS] interface virtual-template 1
[LNS-virtual-template1] ip address 192.168.0.20 255.255.255.0
[LNS-virtual-template1] remote address pool 1
[LNS-virtual-template1] ppp authentication-mode pap
# Configure the virtual template interface to not check the next hop of a packet to be sent.
[LNS-Virtual-Template1] ppp ignore match-next-hop
[LNS-virtual-template1] quit
# Configure local authentication for VPN users.
[LNS] domain system
[LNS-isp-system] authentication ppp local
[LNS-isp-system] ip pool 1 192.168.0.2 192.168.0.100
[LNS-isp-system] quit
# Enable L2TP and create an L2TP group.
[LNS] l2tp enable
[LNS] l2tp-group 1
# Configure the local tunnel name and specify the virtual template interface for receiving packets and the
tunnel name on the LAC.