H3C Technologies H3C SecPath F1000-E - Manual (Page 51)

18
To do… Use the command… Remarks
Display information about L2TP
sessions
display l2tp session Available in any view
L2TP Configuration Examples
Configuration Example for NAS-Initiated VPN
Network requirements
A VPN user accesses the corporate headquarters as follows:
1. The user dials in to the NAS.
2. The NAS determines whether the user is a valid VPN client. If so, it initiates a tunneling request to
the LNS.
3. After a tunnel is set up between the NAS and the LNS, the NAS transfers the results of its
negotiation with the VPN user to the LNS.
4. The LNS decides whether to accept the connection request according to the negotiated results.
5. The user communicates with the headquarters over the tunnel between the NAS and the LNS.
Figure 9 Network diagram for the NAS-initiated VPN
Configuration procedure
Step1 LAC side configuration
• Configure the NAS
# Configure IP addresses for interfaces. (Omitted)
# Create a local user named vpdnuser, set the password, and enable the PPP service.
<LAC> system-view
[LAC] local-user vpdnuser
[LAC-luser-vpdnuser] password simple Hello
[LAC-luser-vpdnuser] service-type ppp
[LAC-luser-vpdnuser] quit
# Configure interface Async 1/0.
[LAC] interface async 1/0
[LAC-Async1/0] ip address 1.1.1.1 255.255.255.0
[LAC-Async1/0] ppp authentication-mode chap
[LAC-Async1/0] quit
# Enable L2TP.
[LAC] l2tp enable