H3C Technologies H3C Intelligent Management Center User Manual
Page 20
13
{
If installing from DVD on Red Hat Linux 6, copy all installation files to the local server.
{
If installing on Linux, make sure the installer can run the chmod –R 775 .\linux\install\install.sh
command.
3.
Run .\windows\install\install.bat (or .\linux\install\install.sh). A window will appear, as shown
in
, asking you to select a country/region, language, and installation type.
Figure 1 Select Locale (on Windows Server 2008 R2)
4.
Select the country/region, language, and installation type.
IMC supports typical and custom installation.
{
Typical—Install and deploy all platform subcomponents on the current server. A typical
installation is a good place to start a centralized deployment. All subcomponents of the IMC
Platform must use a local database, embedded or separate.
{
Custom—Allows you to select IMC Platform subcomponents to install and deploy on the current
server and specify a remote database server.
To install IMC on a virtual machine, configure the VM access parameters on the VM Installation
Check dialog box, as shown in
:
a.
The VM Type defaults to VMware and cannot be changed.
b.
Enter the IP address of the VMware host in the Host IP field. The host must be ESXi. VMware
Workstation is not supported.
c.
Select the protocol type used to access the VMware host from the Access Protocol Type list.
Options are HTTP and HTTPS (default). To select a protocol type, contact the host administrator.
d.
Set the port number to access the host where the VMware is deployed in the Port Number field.
The default value is 80 for HTTP and 443 for HTTPS. To set the port number, contact the host
administrator.