Grass Valley 8925DMB-B - Manual (Page 19)

8925DMB-B and -U — Instruction Manual 19
Power Up
Power Up
The on-board LED indicators are illustrated in Figure 7 . Upon power-up,
the green PWR LED should light on. The CONFIG and FAULT LEDs
should briefly light on and the COMM LED should blink during the
module initialization.
Note When a module is first plugged into a GeckoFlex frame, the 8900NET module
(if present) may report a momentary fault. This will clear once the module has
booted up.
Operation Indicator LEDs
With a valid input signal present, the VID IN PRES (green) LED should be
on. Refer to
Table 3 on page 20 to see a complete list of possible operating
conditions and the resulting indicator status.
Note LED colors are highlighted in Figure 7 for reference only. They are not
intended to show the state of the module at power up.
Figure 7. LEDs Indicators