Grass Valley 8949SVM-LOC - Manual (Page 27)

8949SVM-LOC/-UMD—Instruction Manual 27
Networking the 8949SVM
Figure 11. Enter IP Address and Subnet Mask
8. This will now allow communication between the PC and the module
for updating software. Refer to
Updating Software on page 29 .
Access Through a Non-DHCP Network
1. Connect the unit to a network hub or switch using a standard (not
cross-wired) RJ-45 Ethernet cable.
2. Determine the correct IP address and subnet mask from your Network
Administrator.
3. If you need to change your IP address and/or subnet mask, use the
paddle switch controls to enter the correct values in the Initial Settings
control group as summarized in
Table 1 on page 20 and described in
step by step detail in Set Default IP, IP Net Mask and Default Gateway on
page 24 .
4. When the IP address setup is complete, go directly to Updating Software
on page 29 .