Grass Valley 8995DNC v.1.3.0 - Manual (Page 50)

50 8995UPC/DNC/UDX — Instruction Manual
Configuration
Select the Apply Settings button to perform the action. Some conversions (typ-
ically up and down conversion) require a reconfiguring of parameters on
the module and a
Please standby ... reconfiguring message ( Figure 27 ) will
appear while the operation is performed.
Note Once the web page reappears, it may be necessary to use the Refresh button
to update the page to show the correct values now configured.
Figure 27. Please Stand By Message
When the module detects an invalid condition relating to input/output
conversion (such as down converting between different line rates 59.94 and
50 for example), a warning message will appear similar to the one shown
in
Figure 28 . The warning message will indicate why this operation is not
supported.
Figure 28. Invalid Signal Conversion Warning Message
Configuration errors on the System Config web page will also be reported
on the Status web page as shown in
Figure 23 on page 45 .