Grass Valley DD35 Family v.3.4.5 - Manual (Page 11)

Supplement Software Release V3.4.5 DD35 Production Switcher
7 Operating Instructions – Rev. 0 / 7.2002
Example Settings
FX direct Ram Output option installed:
Probably your setting will be:
DVX1: DVX1 RAM1: RAM1
DVX2: DVX2 RAM2: RAM2
DVX3: DVX3 RAM3: RAM3
DVX4: DVX4 RAM4: RAM4
Since there is no need to change these settings, you probably will hide the com-
plete FX outputs section (DVx Settings menu).
FX direct Ram Output option not installed:
Since this option is not installed, you should hide the RAM outputs part of the FX
outputs section.
For a fully equipped FX processor your setting could be:
DVX1: DVX1
DVX2: DVX2
DVX3: RAM1
DVX4: RAM3
In this case you still could use all 4 channels of DVE in combiner mode (DVX1 =
DVE video, DVX2 = DVE key) as one DVE or two pairs with superblack (DVX1 =
combiner1 on superblack, DVX2 = combiner2 on superblack) as two independent
DVE’s.
On DVX3 you can access RAM recorder1 – which can be cascaded with RAM re-
corder2.
On DVX4 you can access RAM recorder3 – which can be cascaded with RAM re-
corder4.
You can change these settings on the fly by macros or by timelines. To indicate a
deviation from your default setting you can define your defaults in the DVx Settings
menu.
A deviation will then be highlighted.
Note:
The sources named “RAM1” ... “RAM4” which are available as internal
sources can only be used on the sendbuses to the DVx! When selected here
this will feed the according RAM recorder output directly into the DVx chan-
nel in a shortcirciut mode on the FX processor. “RAM1” ... “RAM4” selected
on any other bus will generate full frame white. So be careful when rename
the inputs for the re–entered RAM outputs to not get confused with the iner-
nal names.