Automation, Imc panels, Presstation / presmaster – Grass Valley Imagestore 750 v.3.0.1 User Manual

Page 166: Gpi controller switch

Advertising
background image

150

Control and Monitoring

Control Options

At times, additional symbols are shown on the top line of the display, at the right hand edge.
These highlight the state of the A/B Mixer (video or audio), the keyers or voice-overs. These are
the symbols and their meaning:

Note: The front panel is normally used only during commissioning and is not suitable as a
general control method because the Imagestore 750 is likely to be remotely located in an equip-
ment rack. You can, however, use the Imagestore 750’s web interface (and its front panel mirror)
to control the front panel remotely. (See

Front Panel Mirror

on page 178.)

Automation

External automation drivers using the Oxtel series protocol can control all aspects of Imagestore
750 behavior either through a serial port or over Ethernet. If your system includes the master
control option, it can also be controlled using Presmaster automation.

Note: For details of the Oxtel and Presmaster automation protocols, see the automation publica-
tions listed under

Applicable Publications and Tools

on page 3.

iMC Panels

Any iMC panel (iMC-Panel-200, iMC-Panel-300, or iMC-Panel-GUI) can be used to provide
manual control of an Imagestore 750 and an override to automation. The Imagestore 750 must
include the master control option if it is to be controlled by an iMC panel.

Note: For details about the iMC panels, see the master control documentation listed under

Applicable Publications and Tools

on page 3.

PresStation / Presmaster

A PresStation master control panel can also provide manual control of an Imagestore 750 and an
override to automation. With this setup, the master control logic lies within the Presmaster
product.

Note: See the Presmaster documentation listed under

Applicable Publications and Tools

on

page 3.

Warning: PresStation panels are not compatible with iMC panels.

GPI Controller Switch

GPI control circuitry connected to the Imagestore 750’s GPI connector can be used to trigger
internal command macros. See

GPI Inputs and Macros

on page 48 and

GPIO / LTC

on page 207

for more detail.

A

Source A

B

Source B

Intermediate state, transition being processed.

↑ Image/voice-over keyed up (to air)
↓ Image/voice-over keyed down (from air)
B

Fade to black

S

Fade to silence

Advertising