Grass Valley K2 Level 3 RAID Dec.09 2005 - Manual (Page 47)

November 23, 2005 Level 3 RAID Instruction Manual 47
Installing a RAID controller or expansion adapter
4. Remove the module as illustrated in the following diagram.
CAUTION: The module might be hot.
Installing a RAID controller or expansion adapter
To install a RAID controller or expansion adapter:
1. Set the chassis address switch on a replacement expansion adapter to be the same
as that of the defective expansion adapter. For the switch locations, see
“Addressing requirements” on page 26 .
1
2 Pull
module
out
Swing ejector out
to 90 degrees
!