Grass Valley PDR 200 Fibre Channel - Manual (Page 18)

Fibre Channel Installation
6 PDR 200 Fibre Channel Installation Manual
Fibre Channel Cable
The cable connecting the Profile to a Hub is a 5 meter, copper wire cable with
a DB-9 connector on each end. Note that other lengths of cable are available
from your Tektronix representative. Also note that distances greater than 25
meters require a fiber-optic cable with copper-to-fiber adapters.
NOTE: Minimum cable lengths should be used to reduce signal degradation
and error rates.
Sticker Set
A standard set of stickers, including a Fibre Channel sticker, is provided so that
your Profile board IDs at the back of the chassis can be updated after the
installation of the Fibre Channel kit.