Chassis address setting requirement, Chassis address setting – Grass Valley PFR600/E User Manual
Page 28
Chapter 2 PFR600 Series Installation Information
28
PFR 600/E Instruction Manual
20 February 2004
Chassis address setting requirement
Each PFR600/E storage chassis has a chassis address switch that must be set to a unique
chassis address. Valid chassis addresses are 0-9 with 0 being reserved for the PFR600
RAID Chassis. All chassis are shipped with the chassis address set to 0.
The chassis address switch is located inside the chassis on the midplane board. The
following figures show how to gain access to the switch by removing the board canisters.
CAUTION: Refer to the PVS Series Installation Guide
you received with your Profile XP
storage system or the Open SAN Instruction Manual for step-by-step instructions for
setting the chassis address.
2930
LBB goes
in the top slot (B)
LBB goes
in the bottom slot (A)
Enclosure