Grass Valley PFR600/E - Manual (Page 36)

Chapter 2 PFR600 Series Installation Information
36 PFR 600/E Instruction Manual 20 February 2004
PFR600/E power-up and initialization
This section gives information about connecting power and powering-on the
PFR600/E system.
Connecting electrical cables
For each chassis, there are two electrical cables which should be connected to separate
outside power sources, as shown.
WARNING: Make sure the power cords meet local safety and electrical
standards.
CAUTION: The PFR600/E system must be electrically grounded.
Operating the system without proper grounding can damage disk drives. If
the outlet you use is not grounded, make sure that a licensed electrician
replaces it and installs a grounding conductor.
To prevent the plug from inadvertently being unplugged, secure the electrical cable into
the outlet by doing the following:
1. Insert the plug.
2. Press the small tabs together.
3. Slide the lock past the plug until the tabs snap into the plug housing.
2924a
To power
source
To power
source
On/Off standby switches
!
!
2798
Press small tabs
together
Snap to here