Polaris 2003 Victory Classic Cruiser - Manual (Page 54)

52
INSTRUMENTS, FEATURES AND CONTROLS
Multi-Function Display (MFD)
Clock
A clock icon appears in the display when in clock mode. When the clock is operating normally, the colon between
the hour and minutes flashes.
To set the clock, the ignition switch must be in the ON position with the MFD in clock mode.
1. Press and hold the SET button for THREE seconds when in clock mode. The hour digits should flash.
2. Press the SET button to select the desired hour.
3. Press the MODE button to accept the new hour setting. The ten-minute digit should flash.
4. Press the SET button to select the desired ten-minute.
5. Press the MODE button to accept the new ten-minute setting. The minute digit should flash.
6. Press the SET button to select the desired minute.
7. Press the MODE button to accept the new minute setting. The clock should return to normal operation, and the
colon should flash.
To change to the next MFD function, press the MODE button.
Notice The multi-function display (MFD) clock will not function if the battery voltage drops below 11.5 volts.
The clock will reset to 12:00 if the battery is disconnected.