Emotiva USP-1 - Manual (Page 13)

13
USP-1 Remote
hile
The USP-1 has a dedicated remote control that offers discrete
buttons for most of the critical USP-1 controls.
Power Buttons
Discrete buttons to turn the USP-1 on and off, as indicated.
Volume Controls
Applies continuous increase (+) or decrease (-) in volume levels w
buttons are held down. The USP-1 volume knob moves in
correspondence with these controls.
Source Selection Buttons
These buttons select the various source inputs of the USP-1. LED’s
on the front panel of the USP-1 will light in correspondence with the
selected input
• CD – selects CD player input as source.
• PHONO – selects Phono input as source.
• TUNER – selects Tuner input as source.
• AUX1 – selects Aux1 input as source.
• AUX2 – selects Aux2 input as source.
Mode Buttons
Select the indicated function for the USP-1. Front panel LED’s light
in correspondence with the selected mode.
• MONO – switches audio output from stereo to mono.
Pressing a second time restores signal to stereo (default).
• TAPE - Push to select the inputs on the Tape Monitor section
to pass through the outputs of the tape monitor section. When not
selected, any selected input passes through the output of the Tape
Monitor output.
• HT (Home Theater Bypass) –When pushed, the HT Input
connections will pass through the USP-1, allowing the left channel,
right channel and subwoofer to be controlled by a connected multi-
channel processor, bypassing the USP-1 completely.
• MUTE - mutes the USP-1.
Changing the Battery
The USP-1 remote is powered by 2 AAA batteries. To add fresh
batteries, press in the battery cover tab, remove the battery cover,
exchange the batteries and orient the negative and positive ends as
indicated by the images in the battery compartment. Emotiva recommends using alkaline batteries.