HEIDENHAIN TNC 306 Service Manual - Manual (Page 75)

SERVICE MANUAL TNC 306/360
Page 68
HEIDENHAIN Service
15.2.3 Output of a Selected NC Program
Press key Function
Activate operating mode PROGRAMMING AND EDITING
EXT Prepare TNC for data output
or Select item OUTPUT SELECTED PROGRAM
ENT Activate selection
or select desired program
ENT
NO
ENT
Output program
Do not output program
Change operating mode
15.2.4 Output of All NC programs
Press Key Function
Activate operating mode PROGRAMMING AND EDITING
ENT Prepare TNC for data output
or Select item OUTPUT ALL PROGRAMS
ENT Start output of data
When data transfer is finished, the dialog EXTERNAL DATA OUTPUT is cleared
and the NC program downloaded last is activated.
Change operating mode