HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 105)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 105
2.5 Units—Dr
illing in C axis
"ICP boring/countersinking, C axis" unit
The unit machines a single hole or a hole pattern on the face or lateral
surface. Using ICP, you define the hole positions as well as further
details for boring or countersinking.
Unit name: G72_ICP_C / Cycle: G72 (see page 327)
Access to the technology database:
 Machining operation: Drilling
 Affected parameters: F, S
Pattern form
FK
see page 62
NS Starting block no. of contour
Cycle form
E
Delay (dwell time at end of hole) (default: 0)
D Retraction at
 0: Rapid traverse
 1: Feed rate
RB Retraction plane (default: return to the starting position or
to the safety clearance)
Further forms: see page 60