HEIDENHAIN TNC 320 (77185x-01) Cycle programming - Manual (Page 32)

Contents
32
TNC 320 | User's Manual Cycle Programming | 3/2014
15.9 DATUM FROM INSIDE OF CORNER (Cycle 415, DIN/ISO: G415)....................................................344
Cycle run............................................................................................................................................... 344
Please note while programming:.......................................................................................................... 345
Cycle parameters.................................................................................................................................. 346
15.10DATUM CIRCLE CENTER (Cycle 416, DIN/ISO: G416)..................................................................... 348
Cycle run............................................................................................................................................... 348
Please note while programming:.......................................................................................................... 349
Cycle parameters.................................................................................................................................. 350
15.11 DATUM IN TOUCH PROBE AXIS (Cycle 417, DIN/ISO: G417)..........................................................352
Cycle run............................................................................................................................................... 352
Please note while programming:.......................................................................................................... 352
Cycle parameters.................................................................................................................................. 353
15.12DATUM AT CENTER OF 4 HOLES (Cycle 418, DIN/ISO: G418)........................................................354
Cycle run............................................................................................................................................... 354
Please note while programming:.......................................................................................................... 355
Cycle parameters.................................................................................................................................. 356
15.13DATUM IN ONE AXIS (Cycle 419, DIN/ISO: G419)...........................................................................358
Cycle run............................................................................................................................................... 358
Please note while programming:.......................................................................................................... 358
Cycle parameters.................................................................................................................................. 359
15.14Example: Datum setting in center of a circular segment and on top surface of workpiece.........361
15.15Example: Datum setting on top surface of workpiece and in center of a bolt hole circle............ 362