HEIDENHAIN iTNC 530 (340 49x-03) ISO programming - Manual (Page 669)

Table of Miscellaneous Functions
M Effect Effective at block... Start End Page
M00 Stop program/Spindle STOP/Coolant OFF „ Page 251
M01 Optional program STOP
„
Page 575
M02 Stop program/Spindle STOP/Coolant OFF/Clear status display
(depending on machine parameter)/Go to block 1 „ Page 251
M03
M04
M05 Spindle ON clockwise
Spindle ON counterclockwise
Spindle STOP „
„
„
Page 251
M06 Tool change/Stop program run (depending on machine parameter)/Spindle STOP
„
Page 251
M08
M09 Coolant ON
Coolant OFF „
„
Page 251
M13
M14 Spindle ON clockwise/Coolant ON
Spindle ON counterclockwise/Coolant ON
„
„
Page 251
M30 Same function as M02 „ Page 251
M89 Vacant miscellaneous function or
Cycle call, modally effective (depending on machine parameter) „
„
Page 285
M90 Only in lag mode: Constant contouring speed at corners „ Page 255
M91 Within the positioning block: Coordinates are referenced to machine datum „ Page 252
M92 Within the positioning block: Coordinates are referenced to position defined by machine
tool builder, such as tool change position
„
Page 252
M94 Reduce display of rotary axis to value under 360° „ Page 272
M97 Machine small contour steps
„
Page 257
M98 Machine open contours completely „ Page 259
M99 Blockwise cycle call „ Page 285
M101
M102 Automatic tool change with replacement tool if maximum tool life has expired
Cancel M101 „
„
Page 195
M103 Reduce feed rate during plunging to factor F (percentage) „ Page 260
M104 Reactivate the datum as last defined
„
Page 254
M105
M106 Machining with second k
v
factor
Machining with first k
v
factor
„
„
Page 640
M107
M108 Suppress error message for replacement tools
Cancel M107
„
„
Page 194