HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 16)

New F
u
nctions with 606 42x
-02
16
New Functions with 606 42x-02
„ New function for opening 3-D data (software option) directly on the
TNC (see "Open 3-D CAD data (software option)" page 255 ff)
„ Improvement of Dynamic Collision Monitoring (DCM):
„ The display of stepped tools has been improved
„ When you select tool carrier kinematics, the TNC now displays a
graphical preview of the carrier kinematics (see “Assigning the
tool-carrier kinematics” on page 180)
„ Extension of the functions for multiple axis machining:
„ In manual mode, you can now also travel the axes again when
TCPM and Tilt Machining Plane are active at the same time
„ You can now also change tools when M128/FUNCTION TCPM is active
„ File management: archiving of files in ZIP archives (see "Archive
files" page 130 ff)
„ The nesting depth for program calls has been increased from 6 to 10
(see “Nesting depth” on page 263)
„ There is now a search function based on tool names available in the
tool selection pop-up window (see “Search for tool names in the
selection window” on page 187)
„ Improvements in pallet machining:
„ The new column FIXTURE has been added to the pallet table to be
able to activate fixtures automatically (see "Pallet Operation with
Tool-Oriented Machining" page 446 ff)
„ The new workpiece status SKIP has been added to the pallet table
(see "Setting up the pallet level" page 452 ff)
„ If a tool sequence list is created for a pallet table, the TNC now
also checks that all the NC programs of the pallet table are
available (see “Calling tool management” on page 193)
„ The new host computer operation was introduced (see “Host
computer operation” on page 593)
„ The SELinux security software is available (see “SELinux security
software” on page 87)