HEIDENHAIN TNC 620 (81760x-01) ISO programming - Manual (Page 61)

Setting up tools 1.5
1
TNC 620 | User's Manual for DIN/ISO Programming | 3/2014
61
1.5 Setting up tools
Selecting the correct operating mode
Tools are set up in the Manual Operation mode:
Press the operating-mode key: The TNC switches
to the
Manual mode of operation
Further information on this topic
Operating modes of the TNC: See "Modes of Operation",
page 71
Preparing and measuring tools
Clamp the required tools in their chucks
When measuring with an external tool presetter: Measure the
tools, note down the length and radius, or transfer them directly
to the machine through a transfer program
When measuring on the machine: store the tools in the tool
changer page 63