HEIDENHAIN TNC 640 (34059x-01) - Manual (Page 32)

32
17.1 Selecting MOD Functions ..... 512
Selecting the MOD functions ..... 512
Changing the settings ..... 512
Exiting the MOD functions ..... 512
Overview of MOD functions ..... 513
17.2 Software Numbers ..... 514
Application ..... 514
17.3 Entering Code Numbers ..... 515
Application ..... 515
17.4 Setting the Data Interfaces ..... 516
Serial interfaces on the TNC 640 ..... 516
Application ..... 516
Setting the RS-232 interface ..... 516
Setting the baud rate (baudRate) ..... 516
Setting the protocol (protocol) ..... 516
Setting the data bits (dataBits) ..... 517
Parity check (parity) ..... 517
Setting the stop bits (stopBits) ..... 517
Setting the handshake (flowControl) ..... 517
Settings for data transfer with the TNCserver PC software ..... 518
Setting the operating mode of the external device (fileSystem) ..... 518
Software for data transfer ..... 519
17.5 Ethernet Interface ..... 521
Introduction ..... 521
Connection possibilities ..... 521
Configuring the TNC ..... 522
17.6 Position Display Types ..... 528
Application ..... 528
17.7 Unit of Measurement ..... 529
Application ..... 529
17.8 Displaying Operating Times ..... 530
Application ..... 530
17 MOD Functions ..... 511