Extron electronic DVI DA4 - Manual (Page 16)

DVI DA2 and DVI DA4 • Installation and Operation
Installation and Operation, cont’d
2-4
4 . Attach the shelf to the rack with the four provided
10-32 x 3.4" screws.
Under-desk mounting
The DVI DA2 and DVI DA4 can be mounted under furniture
using the optional Extron MBU 125 under-desk mounting kit
(part # 70-077-01).
Under furniture mounting
To mount the unit under a desk or table:
1
. If necessary, remove rubber feet from the bottom of the
unit.
2 . Secure the under-desk mounting brackets to the unit with
the four provided 4-40 x 3/16" screws.
3 . Hold the unit, with the mounting brackets attached, under
the furniture where it will be secured. Mark the position of
the holes on the underside of the furniture.
4 . In the marked positions, drill four pilot holes 3/32" (2 mm)
in diameter and 1/4" (6 mm) deep.
5 . Insert the four provided wood screws into the pilot holes
and tighten until approximately 1/4" (6 mm) of the screw
head is protruding.
6 . Guide the holes of the mounting brackets over the
protruding screw head and slide the unit forward or
backward to seat it firmly under the furniture.
7 . Tighten all four wood screws to secure the unit in place.