Enviro Cara DR C-11500 - Manual (Page 11)

To install the burner:
1. Insert the mixing tube into the mixing
tube box (refer to Figure 8 or 9).
2. When the burner is resting in the
firebox ensure that the front edge of
the burner is lined up with the front
lip of the firebox (see Figure 10 or
11).
3. Re-install the log set or rock set
(see s
econdary
i
nstaLation
- L
og
s
et
i
nstaLLation
or s
econdary
i
nstaLation
-
r
ock
s
et
i
nstaLLation
) and the door.
4. Check burner for proper operation.
Figure 11: Align Rock Set Burner With Firebox.
Maintenance And Service
11
Figure 10: Align Log Set Burner With Firebox.
F
iRebox
b
aFFle
R
emoval
:
The firebox baffle can be remove when cleaning the venting pipe.
1. Remove the glass door as shown in the M
aintenance and
s
ervice
- g
Lass
d
oor
r
eMovaL
.
2. Remove the two (2) Torx T-20 screws holding the front of the firebox baffle in place (refer to Figure
12). IMPORTANT: The baffle should be held in place when the screws are removed to prevent it from
falling, which could damage the firebox liner, log set, or rock set.
3. Carefully push the back of the baffle up while pulling the front down (see A’s in Figure 13) then pull
the baffle out of the firebox.
4. Re-install the firebox baffle and the door when done.
Figure 13: Firebox Baffle Removal. Figure 12: Firebox Baffle Screws Removal.