Yaskawa G5 PID for Trim Control - Manual (Page 11)

Date: 07/01/04, Rev: 04-07 Page 11 of 12 TM.G5SW.012
Verifying the Installed Software Number
For the PID for trim control software option, the software number is VSG112052. The software installed in the drive can
be verified by either reading it off of the control board or calling it up on the digital operator.
In order to read the software number off of the control board, take the
cover off of the drive and look for the white sticker on the main control
board. This sticker is just to the right of connector 2CN. On it is the
version of the control board, then a dash, then the last 4 digits of the
software number (see Figure 1). The “S” before the number can be
disregarded.
In order to view the last 5 digits of the software number from the digital
operator, bring up drive parameter U1-14 (FLASH ID). This is done
by powering up the drive and using the following key sequence:
, , ,
(13 times)
Software Number Location