Elektra Beckum Spindle Moulder TF 100 M - Manual (Page 2)

ENG
2 User Responsibility
This machine will perform in conformity with the description contained in the instructions provided. This machine
must be checked periodically. Defective equipment (including power cables) should not be used. Parts that are
broken, missing, plainly worn, distorted or contaminated, should be replaced immediately. Should such repair or
replacement become necessary, it is recommended that such repairs are carried out by qualified persons
approved by Elektra Beckum or its representatives.
1 Specifications TF 100 M 2.2 WN TF 100 M 2.8 DN
Table top 523 x 423 mm 523 x 423 mm
Workpiece support area 150-210 x 600 mm 150-210 x 600 mm
Working height from floor 850 mm 850 mm
Table opening Ø 150 mm 150 mm
Table rings 2 2
Fence travel 30 mm 30 mm
Dust extraction outlet Ø 100 mm 100 mm
Max. tool diameter 150 mm 150 mm
Max. tool height 60 mm 60 mm
Spindle diameter 30 mm 30 mm
Spacing collar Ø 50 mm 50 mm
Spindle vertical adjustment 100 mm 100 mm
Spindle speeds 4000/6000/7500 min -1 4000/6000/7500 min -1
Motor input capacity P
1
2.2 kW S6 - 40% 2.8 kW S6 - 40%
Motor output capacity P
2
1.1 kW S6 - 100% 1.4 kW S6 - 100 %
Operating voltage 220-240 V 1~50 Hz 380-415 V 3~50 Hz
Noise Emission
The noise emission levels shown below have been established by measuring methods according to:
DIN 45 635, part 1651.
The A-sound power levels (L
WA
) were rounded to full dB(A).
1. TF 100 operating under no load
A-sound pressure level L
pA
77 dB(A) 77 dB(A)
A-sound power level L
WA
86 dB(A) 86 dB(A)
2. TF 100 operating under load
A-sound pressure level L
pA
82 dB(A) 82 dB(A)
A-sound power level L
WA
91 dB(A) 77 dB(A)
Contents
1 Specifications
2 User Responsibility
3 Standard Delivery
4 Optional Accessories
5 Final Assembly
6 Installation
7 Commissioning
7.1 1-Phase Power Supply
7.2 3-Phase Power Supply
7.3 Direction Of Rotation
7.4 Switch
7.5 Overload Protection
7.6 No-Voltage Release
7.7 Dust Collection
7.8 Dust Collector Automatic Start
8 Safety Information
9 Workpiece Dimensions
10 Scope Of Application
11 Tool Dimensions/Cutting Speeds
12 Jigs And Push Blocks
13 Controls
13.1 Definitions
13.2 Mounting A Tool
13.3 Spindle Speed Setting/Changing
13.4 Tool Height Setting
13.5 Fence And Fence Plate Setting
13.6 Cutter Guard Setting
14
Operation
14.1 Tools
14.2 Stock Prechecking
14.3 Moulding Strips
14.4 Moulding Boards
14.5 Making Tenons
14.6 Set-In Work
15
Care And Maintenance
16 Electrical Wiring Diagrams
17 Spare Parts List
2