Elektra Beckum Spindle Moulder TF 100 M - Manual (Page 3)

This machine or any of its parts should not be altered or changed from standard specifications. The user of this
machine shall have the sole responsibility for any malfunction which results from improper use or unauthorized
modification from standard specifications, faulty maintenance, damage or improper repair by anyone other than
qualified persons approved by Elektra Beckum or its representatives.
Elektra Beckum reserves the right to change specifications and design without prior notice and without incurring
obligation of any kind.
Equipment referred to as available or optional may be at extra cost.
3 Standard Accessories
Spacing collars: 1 pc. 25 mm, 1 pc. 16 mm,
2 pcs. 10 mm, 2 pcs. 8 mm,
2 pcs. 5 mm
Spindle nut: M 30x2
Fence
Fence plates
SUVA style safety cutter guard
Tool set
Instructions
3
6 Installation
Important!
This spindle moulder model TF 100 M must be anchored to the floor for
stability. A machine not anchored to the floor may fall over while in
operation.
Use suitable means for anchoring, e.g. anchoring bolts or expansion
anchors Ø 8 mm.
Place fence on table and screw
starknobs onto stud bolts. Slide hexagon bar into fence carrier
and lock with starknob screw. Install holddown shoe and spring on
hexagon bar.
5 Final Assembly
Set table extension level with the table. Install cutter guard carrier on the fence.
Use 4 each
- hexagon head screw M 6x25
- hex. nut M 6 self-locking
Screw both stud bolts into the tapped
bore holes of the table.
4 Optional Accessories
Table Extension TF 100 Stock-no. 0914003598
Sliding Carriage TF 100 Stock-no. 0914015600
Moulding Tools see separate catalogue