JBL Synthesis Everest DD67000 - Manual (Page 12)

23
All components of the Project Everest system have been very carefully packed for
maximum protection against damage. As with any superior audio product, it is advisable
to keep the original packing materials, in case it is necessary to transport the Project
Everest system. Because of the bulk and weight of this loudspeaker, at least two people
are required to unpack it.
NOTE: Stainless-steel round feet are installed on the bottom of the speaker cabinet.
To avoid damage to your floor, we strongly advise unpacking the speakers on a well-
protected surface, such as a thick carpet or cardboard. (Note: Your loudspeaker system
is packed with a protective wrapping, but this is omitted for clarity in the drawings below.)
1. Cut the straps securing the carton with scissors or a knife. (Please be careful so that
the cut straps don’t spring up and hit your face or hand.)
2. a) Slowly lift the top cover up and remove it. b) If there is not enough room above the
box to pull off the top cover, carefully cut the side and top of it with a knife and pull
it horizontally.
a B
unPacking the
Project everest
system
3