JBL Synthesis Everest DD67000 - Manual (Page 17)

33
The DD65000 and DD67000 have two control panels under the cover at the center
bottom of the front baffle. Shorting bars and switches on the control panels allow you to
switch orientation of the system, engage bi-amplification if desired and adjust woofer and
high-frequency levels. After removing the grille (see Removing the Grilles, in Chapter 3),
remove the control panel cover to expose the adjustments.
To change setups using shorting bars, use the supplied hexagonal driver to remove the
screws securing the bar. Move the bar according to the setup you require and then re-
install the screws.
attention: To avoid poor electrical contact caused by loose shorting bar mounting
screws, make sure that the screws are firmly installed. However, if you overtighten, there
is a risk of damaging the terminals themselves. Please use the supplied hexagonal driver
and tighten screws with reasonable torque, by hand only.
DO NOT USE POWERED
SCREWDRIVERS OF ANY TYPE.
Project everest
aDjustments
7