Lanner LEC-3110 - Manual (Page 8)

6
Introduction
Chapter 2
Embedded and Industrial Computing
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server The front panel Power On/Standby button
does not completely shut off system power
Portions of the power supply and some internal
circuitry remain active until AC power is removed
Unscrew the 6 threaded screws from the top cover of 1
the LEC-3110 System
Slide the cover backwards and open the cover
2
upwards
Installing the System Memory
The motherboard supports DDR2 memory It comes with
one Double Data Rate(DDR2) Small Outline Dual Inline
Memory Modules (SO-DIMM) socket
Align the cutout of the SO-DIMM with the notch of the 1
memory slot
Install the SO-DIMM 2
Cutout
Notch
Note:
The system already has 1GB onboard memory 1
and can support additional memory with the
DDR3 SO-DIMM socket up to 4 GB in maximum
Installing the Hard Disk
The system can accommodate one Serial-ATA disks Follow
these steps to install a hard disk into the LEC-3110:
Unscrew the 4 screws on the hard disk tray to take out 1
the hard disk tray from the system
Place hard disk on the hard disk tray and align the holes
2
of the hard disk with the mounting holes of the tray
Secure the hard disk with 4 mounting screws on the
3
hard disk tray
Connect the Serial-ATA power and drive cables to the
4
hard disk’s power and data connectors respectively
Plug the Serial-ATA data cable to the Serial-ATA
5
Connector on the main board
Plug the Serial-ATA power cable to the Serial-ATA
6
Power Connector on the main board
Put the hard disk tray with the installed hard disk back
7
and fasten it to the system with the mounting screws 1