Lanzar OPTIX - Manual (Page 2)

- 1 -
Congratulations on your purchase of a LANZAR Crossover. This product has been designed
and built to deliver excellent sound quality and long lasting high performance. We are sure you
will enjoy listening to your favorite music with this LANZAR component in your car audio System.
For best result a professional car stereo installer for application advice or troubleshooting. Thank
you for choosing LANZAR products for your auto-sound system. Everything else is just noise
INTRODUCTION
FEATURES
SUBWOOFER CHANNEL:
* +12dB Bass Boost
* Phase Shift Switch
* Stereo/Mono Switch
* Output Level Control
* Exclusive Remote Subwoofer Level Control
* Low Pass Frequency Selector 50Hz to 160Hz
* Bass Boost Frequency Selector 40Hz to 120Hz FRONT AND REAR CHANNEL:
* High Pass Frequency Selector
32Hz to 800Hz
* Frequencies Multiplier x1 or x10
* Signal Gain Control
SPECIFICATIONS
Power Supply : 14.4 volts DC negative ground
Input current ： 0.5 amp max
Distortion ： 0.01 ％ THD at 1V output level
Frequency response ： 10Hz- 30K Hz, ±3dB
S/N ratio (A weighted) ： > 95 dB
Separation ： 60 dB
Crossover frequencies (continuously variable) ：
Front High-pass ： (x1) : 32-800 Hz (x10) : 320Hz- 8KHz
Rear High-pass ： (x1) : 32-800 Hz (x10) : 320Hz- 8KHz
Subwoofer ： 50-160 Hz
Crossover slope rate ： 12 dB per octave 2nd Order Butter worth
Subwoofer boost ： Single octave 0 dB to 12 dB (variable) at 40 to 120Hz (variable)
Input impedance ： > 10K Ohms
Output impedance ： < 1K Ohms
Output gain ： +3 dB
Output voltage level ： 5 volts max
Dimensions ： 150mm x 190mm x 35mm
1. Find a suitable location in the vehicle to mount the crossover.
2. Bolt the crossover to the mounting surface.
3. Using the screw terminals provided, connect minimum 16 gauge wire from the power,
Ground and remote terminals. Connect the shortest possible wire to a chassis ground point. The (+)
12V connection should be made directly to the car battery, and the remote should be connected to
the Remote Turn On Lead of your head unit. When connecting directly to the battery, install a 1A
Fuse within 18 inches of the battery terminal.
4. Connect all line inputs and outputs using high-quality RCA cables.
5. Recheck all connections before powering up.
6. Set all level controls to their minimum positions and set all crossover controls, switches, etc. To
the desired frequency or position.
7. Once the system is powered up, set the volume control on the head unit to a moderate level where
your normal speaking voice can be heard while the music is playing.
8. Further fine tuning of the various controls may be necessary to obtain the desired results.
9. When unsure about installation or system tuning, please consult an authorized LANZAR dealer.
INTALLATION