Empire Comfort Systems CHR - Manual (Page 6)

Page 6 CHG/CHR
1. Remove packing material from top of box.
2. Lift chimney section out and set aside.
3. Remove remaining items and packing from inside outdoor
gas fireplace firebox.
4. Lift firebox out of box and sit on flat surface near desired final
location. Leave adequate room around outdoor gas fireplace
to work. Locking ring for chimney should be facing down.
Figure 5
5. Remove washers and nuts from three legs. Install the three
legs using the bolts, washers and nuts provided. Reach
through the opening in the outdoor gas fireplace to tighten the
leg bolts securely.
Figure 5
6. Invert the outdoor gas fireplace firebox to sit on its legs.
7. Remove the 4 5/8" bolt and 5/16 nut that are holding the
burner in place. Carefully remove the burner from the firebox.
Remove the 2 screws and nuts that are holding the hold down
bar in place. Remove the packing materials from the burner.
Unpack the cast iron logs and set aside.
Figures 6 and 7
8. Holding the burner assembly securely with two hands, tip the
burner to a position where it will fit through the front door
opening. The gas inlet plumbing, control panel and regulator
hose assembly should be pointing to the left and somewhat
down as you maneuver the burner through the door. Guide the
regulator hose and control panel through the large hole in the
bottom of the outdoor gas fireplace. The burner should come
to rest on the three flat tabs that protrude from the firebox wall
and the control panel should be approximately centered
between the left front leg and the rear leg. The burner should
be repositioned if needed so that there is an equal gap of
approximately 1/2" between the outer curved perimeter of
the burner and inner firebox wall. The flat edge on the rear of
the burner should be parallel with an imaginary line connecting
the front legs.
Figure 6
Figure 7
Figure 8
9. The installation sequence is to interlock the flicker shield
halves first to prebend the tabs. Place the left half under the
outdoor gas fireplace with the cut-out around the pipe. Interlock
the right half with the left half.
SET-UP INSTRUCTIONS