Linx Technologies MDEV-GPS-SG - Manual (Page 2)

Page 2
SG SERIES RECEIVER DEVELOPMENT BOARD
1. Four AAA Batteries
2. DC Power Jack
3. Power Switch
4. Voltage Regulator
5. USB Interface Module
6. Prototype Area
7. Break-Out Header
8. SG Series Receiver Daughter Board
9. CR2032 Backup Battery (on the back)
10. OLED Display
11. OLED Display Power Switch
TROUBLESHOOTING
If the board fails to work out of the box, then try the following:
• Check the batteries to make sure they are not dead.
• Check to make sure that the power switch is in the correct position.
• Make sure that the jumper is set correctly.
If all of these appear to be in order, please call 800-736-6677 or e-mail
[email protected] for technical support.
1
2
7
3
4
5
6
8
9
11
10
Figure 1: SG Series Receiver Development Board