Curtis TID981 - Manual (Page 2)

26. Tel Line Jack
CAUTION
This telephone must be used with AC/DC adapter.
AC Adapter for DC jack
Specification: Input AC 110V/60Hz
AC 220V/50Hz
Output DC 6V-9V. 100mA
POLARITY OF PLUG +, -
Installation
1. Open the battery compartment cover, load 1X9V batteries.
2. Connect one end of coiled cord to the jack of handset, connect the other end to the
jack of the base set.
3. Plug one end of flat cable to line jack of this phone, plug the other end to wall
jack.
4. Connect the AC/DC adapter to the DC jack of this unit. The batteries are required
even the adapter is used. They can keep the memories and settings when the
power fails. If the power of batteries is low, the low battery icon will appear
replace them soon.
Setting UP
Selecting language mode and area code:
To select the language for displaying the message, follow the instructions below:
1. Install 1X9V battery and connect the adaptor.
2. Press “MODE” Button until “STORE” appears on the LCD.
3. Press “REDIAL” once, “ENG SPA FRA” appears on the LCD.
4. Press “UP” for selecting English mode.
5. Press “DOWN” for selecting Spanish mode.
6. Press “DEL” for selecting French mode.
7. After select the language mode, the unit will display “YES NO DIAL +1”. (This is
used for only some special area.)
8. Press “UP” Button. The phone will dial a “1” before dialing the Full Code.
9. Press “DOWN” Button. The phone will not dial a “1” before dialing the Full
Code.
10. After that, “ENTER AREA CODE” will appears on the LCD.
11. Enter your area code (3-5 Digits).
12. Press “MODE” Button to end this procedure.