Curtis RCD725 - Manual (Page 13)

This continues until all the tracks have been played on that disk, the unit will then enter the
STOP mode.
It is possible to program, the tracks you wish to play in a sequence of your choice, it is
not possible to enter programs during disc play. Press the STOP Button first, and then
follow the instructions below.
ENTERING A PROGRAM
1.Press the PROGRAM Button. The information will be displayed on the display.
2.Select the desired track using the Forward and Reverse SKIP/SEARCH Buttons.
3.Press the PROGRAM Button.
The first program selection is now stored in program memory. The display will now show.
4.Select the next desired track using the Forward and Reverse SKIP/SEARCH Buttons.
5.Press the PROGRAM Button.
Continue entering tracks in this way until all the desired tracks are stored (up to 20).
Notes: If the PLAY/PAUSE Button is pressed before the PROGRAM Button is pressed to store
a track, the track will not be programmed, and the disc will start playing from the first selected
track.
Any track can be programmed to play more than once.
Repeatedly pressing the PROGRAM button will enable you to check the program if required
LISTENING TO PROGRAMMED TRACKS
1. Enter all tracks you want to program into memory following the procedure above.
2. Press the PLAY/PAUSE Button.
3.Disc play will start at the beginning of the first programmed track.
TO CLEAR THE PROGRAM MEMORY
.If the disc is playing, press the STOP Button. The MEMORY will disappears.
The program memory will also be cleared if the disc compartment is opened, if the function is
changed, or if the power is switched off.
SLEEP FUNCTION
When the disc is playing, press SLEEP button on the remote control. SLEEP will blink and 90
indicators will appear. Press SLEEP button to select the time you want (max 90, min 10). Then
the unit will resume playing mode, but SLEEP will display on the screen. And the unit will
change to standby mode at the preset time. For example, you select 10 by SLEEP button; the
unit will change to standby mode after 10 minutes.
TIMER FUNCTION
This function can be used on standby mode and tape mode. Press TIMER button on the
rremote control . The £¢ timer £¢ will appear on the display. Press MODE/REMAIN button, the
£¢ TIMER ON£¢ will display .The£¢ on£¢ will flash. Then press MEMOYR CLOCK button
preset your desired hours .Press MEMORYCLOCK button to confirm. Then the minutes will
flash. Press TRACK/TUNE button preset your desired minutes. Press MEMORY/CLOCK
button to confirm.
11