Electrolux EWX 14540 W - Manual (Page 38)

7. Plug the open holes with the plugs
supplied with the instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets,
rugs etc.
Check that the machine does not touch
the wall or other kitchen units. Level the
washer-dryer by raising or lowering the
feet. The feet may be tight to adjust as
they incorporate a self locking nut, but
the machine MUST be level and stable.
Any necessary adjustment can be made
P1051
P0020
P0256
with a spanner. Accurate levelling
prevents vibration, noise and
displacement of the machine during
operation. Never place cardboard, wood
or similar materials under the machine to
compensate for any unevenness in the
floor.
Water inlet
Do not use the hose from your
previous machine to connect to the
water supply!
1. Connect the hose to a tap with a
3/4” thread.
2. Set the hose correctly by loosening
the ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
Always use the hose supplied with the
appliance. The inlet hose must not be
lengthened.
P0021
P1088
38 electrolux installation
132972140 EN.qxd 26/10/2007 11.40 Pagina 38