EverFocus esrd EDSR-900 - Manual (Page 48)

Press CALL to change settings for CALL / MATRIX monitors.
The Main monitor shows following dialogue:
MONITOR VIEWS / OPERATION
10.2. CALL / MATRIX MONITORS
43
CALL
MATRIX NORMAL STATE SETTING MENU
PRESS CALL TO SET CALL MONITOR
PRESS 1-4 TO SELECT MATRIX
Select the monitor by pressing CALL or the numeric keys 1~4.
The Main monitor shows following dialogue (example with monitor 1):
SETTING MATRIX 1…
SEQUENCE
OSD ON
PRESS 1 – 16 TO SELECT SPOT CAMERA
PRESS SEQ TO SEQUENCE
PRESS DISPLAY TO TURN OSD ON/OFF
PRESS MENU TO EXIT
The current status of the selected monitor is shown in the second and third column
(Sequence / Spot, OSD ON/OFF).
SEQUENCE
Press sequence to activate the standard sequence for this monitor (setup for this
sequence in menu MATRIX, page 27)
MENU
Press MENU to jump back to monitor selection menu.
The numeric keys switch to full screen mode with the selected camera.
NOTE: In menu MATRIX defined events for motion and alarm have
higher priority and will override the manual settings. After end of
any event the monitor switches back to the manual settings.