Curtis SRCD243DG User Manual
Page 4
3
Follow the advice below for safe and appropriate operations.
ON PROTECTION AGAINST LASER ENERGY EXPOSURE
•
As the laser beam used in this compact disc player is harmful to the eyes, do not attempt to disassemble
the casing.
•
Stop operation immediately if any liquid or solid object should fall into the cabinet.
•
Do not touch the lens or poke at it. If you do, you may damage the lens and the player may not operate
properly.
•
Do not put anything in the safety slot. If you do, the laser diode will be ON when the CD door is still open.
•
If the unit is not to be used for a long period of time, make sure that all power sources are disconnected
from the unit. Remove all batteries from the battery compartment, and unplug the power cord or the AC-DC
adaptor if used, from the wall outlet. Make it a practice to remove the AC-DC adaptor by grasping the main
body and not by pulling the cord.
•
This unit employs a laser. The use of controls or adjustment or performance of procedures other than those
specified here may result in exposure to hazardous radiation.
ON PLACEMENT
• Do not use the unit in places which are extremely hot
,
cold, dusty or humid.
• Place the unit on a flat and even surface.
• Do not restrict the air-flow of the unit by placing it in a place with poor ventilation, by covering it with a
cloth or by placing it on a carpet.
ON CONDENSATION
• When left in a heated room where it is warm and damp, water droplets or condensation may form inside the
unit.
• When there is condensation inside the unit, the unit may not function normally.
• Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the unit
before use.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase
the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV
technician for help.