Epson WOODWORKER'S TABLE SAW DW746 User Manual
Page 7
5
English
Specifications
Horsepower 1-3/4
Table Size
27" x 40-3/4"
Miter Angle
60° L&R
Bevel Angle
-2° to 47° Left
Blade Size
10" (254 mm)
Max. Cut Depth
0° Bevel ............... 3-1/8" (79 mm)
Max. Cut Depth
45° Bevel ............. 2-1/8" (54 mm)
RPM, no load
3000
DW746 Basic Unit
Always follow the instructions included with the acces-
sory when asssembling custom accessories to this unit.
Assemble any accessories first.
Tools Included
To aid you with assembly of your new saw, we have included
the following tools.
• T50 torx wrench
• 5 mm hex wrench
• Combination wrench with 16 mm, 13 mm, 10 mm
and 22 mm openings
• Blade wrench with 15/16" and 10 mm box ends.
Tools You Will Need to Supply
• Flat blade screwdrivers
• 16 mm or 5/8" open end wrench or pliers
• Ruler
• Square
• Soft hammer, or regular hammer and block of wood
TO SPEED ASSEMBLY, THE FOLLOWING WOULD BE
HELPFUL:
• 16 mm or 5/8" socket wrench, with 6" extension
• 13 mm or 1/2" socket wrench
• 10 mm open end wrench
• T20 and T25 Torx drivers
• T40
Torx
wrench.
YOUR WILL ALSO NEED:
• Mild solvent cleaner such as mineral spirits, paint thinner or denatured alcohol.
• High-quality paste wax
Necessary Hardware
Your hardware bag, located in the parts box, contains all the necessary nuts, bolts and
washers to assemble the components included with the DW746 Woodworker’s Table Saw.
To make assembly of your saw easier, match the nuts, bolts and washers with the chart on
the previous page. Separate them by size so that you can easily locate the item you need.
Before each step, check your hardware against the chart and identify the pieces you need.
FEATURES (Fig. 1)
Examine Figure 1 to become familiar with the saw and its various parts. The following sec-
tions on assembly and adjustments will refer to these terms and you must know what and
where the parts are.
A. Rear fence rail (included with DW746X)
B. Table top
C. Splitter
D. Blade
E. Blade guard
F. Fence face
G. Rip fence
H. Fence beam
I. Rail lock lever
J. Motor cover
K. Wrench hook
L. Adjustable feet
M. Blade height adjustment wheel
N. Power cord
O. On/Off Switch
P. Blade tilt crank
Q. Front Fence Rail
(included with DW746X)
R. Miter gauge
S. Motor
T. Dust collection port
U. Rip scale pointer
V. Side support table
W. Miter slot
S
T
A
V
C
E
D
F
G
H
I
J
K
L
N
O
P
Q
R
M
U
W
B
FIG. 1