Aquapur ADR 1300 B2 Hand Steam Cleaner - Manual (Page 14)

12 ADR 1300 B2
GB
Storage
Store the cleaned and dryed appliance at a clean and dust-free location. 1)
Wrap the power cable around the attached water tank and secure the end 2)
with the yellow clip on the power cable.
Troubleshooting
PROBLEM
POSSIBLE
CAUSE
POSSIBLE
SOLUTIONS
The appliance does
not function.
The plug is not con-
nected to the mains
power supply.
Connect the appliance
to a mains power socket.
The appliance is dam-
aged. In this case, contact
Customer Services.
It will not produce
steam.
The switch "Descaling"
4 is at the position "I".
Place the switch "Descal-
ing" 4 at the position
"O".
The water tank 3 is
empty. Fill the water tank 3
with water.
The appliance is not yet
heated up. Wait until the green
control lamp 8 glows.
The green control
lamp 8 lights up and
then goes out again.
There is no defect: the
temperature fell briefl y
and the appliance was
then heated up again.
-
The steam volume is
low.
The temperature is too
low. Wait until the appliance
has heated up again.
The appliance is scaled
up. Descale the appliance
(see chapter "Descaling").
Water drips from the
steam nozzle q.
The switch "Descaling"
4 is at the position "I".
Place the switch "Descal-
ing" 4 at the position
"O".
The temperature is too
low. Wait until the appliance
has heated up again.
IB_69184_ADR1300B2_LB4.indb Abs3:12 IB_69184_ADR1300B2_LB4.indb Abs3:12 28.10.2011 9:09:34 Uhr 28.10.2011 9:09:34 Uhr