EverFocus EDR1600 - Manual (Page 29)

Administrator’s Guide and Operating Instructions
25
6.7 Hard Disks Full Action Setup
The Hard Disks Full Actions allow the administrator to define how
the digital video recorder responds when the hard disk drives reach
the maximum storage capacity.
Operations:
After the HDDs Full Action menu item is selected, the HDDs Full
Action Setup dialog box will be shown on the screen.
?? Auto Overwrite – Check this item to enable automatically overwrite
the recorded data from HDD#1 when the hard disk drive capacity
reaches the end. While Auto Overwrite is not enabled, the system
will not overwrite the recorded data until the Administrator or
Supervisor click on the Alarm Reset button. The default setting is
Auto Overwrite enabled. (Note)
?? Duration – Response duration to define how long (in seconds) the
Alarm Out relay and the Buzzer will keep after the full hard disk
capacity is detected. Use the Up/Down arrow buttons to adjust the
value (0-60 seconds).
?? Enable – Check to enable the Alarm Output when the full hard disk
capacity is detected.
?? Alarm Out – To define which Alarm Output will be triggered when
the hard disk capacity is full. NC and NO signals are available,
please refer to Alarm Out Setup. Click on the Down arrow button
to select one of the Alarm Outputs (AO 1-8).