Casio XJ-H2600 User Guide - Manual (Page 34)

34
8.
After entering the new password, press the [ENTER] key.
z This will display a dialog box prompting you to enter the same password again.
9.
Re-enter the same password key sequence you entered in step 7 and then press
the [ENTER] key.
z The message “Your new password has been registered.” indicates that the password has
been changed. Press the [ESC] key.
z If the password you entered in this step is different from the one you entered in step 7, the
message “The password you input is wrong.” appears. Press the [ESC] key to return to step 7.
To change the power on password setting
1.
Perform steps 1 through 5 under “To change the password” (page 33) and
display the Password protection screen.
2.
After confirming that “Power On Password” is selected, use the [
W] and [X] keys
to select either the “On” or “Off” setting.
z Changing the setting from “Off” to “On” will cause the “Prompt for password when power is
turned on?” dialog box to appear. Press the [ENTER] key to confirm that you want to turn on
power on password protection, or [ESC] to exit the dialog box without changing the setting.
3.
After you are finished, press the [MENU] key to exit the setup menu.
To change the custom logo capture password setting
1.
Perform steps 1 through 5 under “To change the password” (page 33) and
display the Password protection screen.
2.
Press the [
T] key to select “Logo Password”.
3.
Use the [
W] and [X] keys to select “On” or “Off”.
z Changing the setting from “Off” to “On” will cause the “Require password verification before
custom logo capture?” dialog box to appear. Press the [ENTER] key to confirm that you want
to turn on custom logo password protection, or [ESC] to exit the dialog box without changing
the setting.
4.
After you are finished, press the [MENU] key to exit the setup menu.