Emerson Nfinity 208 - Manual (Page 13)

Installation
9
2.2 Unloading
2.2.1 Unloading the UPS
!
CAUTION
2. Remove the metal ramp from the bottom of
the UPS.
This UPS is very heavy (see weight in
Table 1). At least two people should
assist in unloading it from the pallet.
3. Fit the ramp flange in the slot in the rear
of the pallet (back of unit) as shown below.
1. Use a ratchet or wrench, 1/2" (13mm), to
remove the four mounting bolts from the
front and rear pallet brackets. Remove the
mounting brackets from the pallet and
UPS. Keep the brackets for future
transportation of the UPS or for additional
stability of the UPS once in place.
4. Using two people, slowly move the UPS
down the ramp until the UPS is on a level
surface.
Pull ramp out from
under front of unit,
then turn ramp over
Fit ramp in
rear of pallet