Extron Electronics MAV Plus Series User Manual
Page 110
4-3
CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide
Front panel Configuration port (matrix sizes up to 1616 only)
This port is hardwired for RS-232 only.
The optional 9-pin D to 2.5 mm mini jack TRS RS-232 cable, part #70-335-01
(figure 4-2) can be used for connection to the Configuration port.
6 feet
(1.8 m)
Part #70-335-01
5
1
9
6
Sleeve (Gnd)
Ring
Tip
9-pin D
Connection
TRS Plug
Pin 2
Computer's RX line
Tip
Pin
3
Computer's
TX
line
Ring
Pin 5
Computer's signal ground
Sleeve
Figure 4-2 — Optional 9-pin TRS RS-232 cable
This port is independent of the rear panel Remote port and is not affected by
changes to the rear panel port’s protocol. This front panel port’s protocol can
be changed, under SIS command control only. See the Command/Response
table for IP SIS commands, later in this chapter, to configure both ports under
SIS control.