Extron Electronics MAV Plus Series - Manual (Page 125)

Programmer’s Guide, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide 4-18
Command/response table for IP SIS commands
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
X50 = Data bits 7, 8
X51
= Stop bits 1, 2
X52 = Port type 0 = RS-232, 1 = RS-422, 2 = RS-485
X53
= Verbose mode 0 = Clear/none (default for Telnet connection)
1 = Verbose mode (default for RS-232/RS-422 connection)
2 = Tagged responses for queries
3 = Verbose mode and tagged for queries
If tagged responses is enabled, all read commands return the constant string and the value as the
set command does (for example, the read matrix name command, Esc CN , returns Ipn• X30 ).
X54 = RAM status 0 = RAM dirty (needs saving to flash)
1 = RAM has been saved (ok to power off/reset)
IP setup commands
Set matrix name (location) Esc X30 CN Ipn• X30
Read matrix name (location) Esc CN X30
Reset matrix name to factory default Esc •CN Ipn• X31
Set time and date Esc X32 CT Ipt X32
Read time and date Esc CT X33
Set GMT offset Esc X34 CZ Ipz X34 The divider between hours and
minutes is a period.
Read GMT offset Esc CZ X34
Set Daylight Savings Time Esc X35 CX Ipx X35 Set the switcher to display the
local time as Daylight Savings
Time (+1 hour) in summer
months.
Read Daylight Savings Time Esc CX X35
Set IP address Esc X36 CI Ipi X36
Read IP address Esc CI X36
Read hardware address Esc CH X37
Read # of open connections Esc CC Icc X38
Set subnet mask Esc X36 CS Ips X36
Read subnet mask Esc CS X36
Set gateway IP address Esc X36 CG Ipg X36
Read gateway IP address Esc CG X36
Set administrator password Esc X39 CA Ipa• X39
Read administrator password Esc CA X39
Reset (clear) administrator password Esc •CA Ipa• X30
Set user password Esc X39 CU Ipu X39
Read user password Esc CU X39
Reset (clear) user password Esc •CU Ipu• X30
Set mail server, domain name Esc X36 , X40 , X39 CM Ipm X36 , X40 , X39
Read mail server, domain name Esc CM X36 , X40 , X39
Set e-mail recipient Esc X41 , X42 CR Ipr X42 , This command sets the recipient.
To receive e-mail notifications,
you must then set the events that
the switcher reports using one or
more separate Set e-mail events
(EM) commands (see next page).
Example Esc 72,[email protected] Ipr•[email protected],
Read e-mail recipient Esc X41 CR Ipr X42
,
X44
,