Extron Electronics MAV Plus Series - Manual (Page 148)

5-21 CrossPoint 450 Plus and MAV Plus Switchers • Matrix Software
Preferences menu
Immediate changes — Causes configuration changes to take
effect immediately.
Hold/verify changes — Delays implementation of
configuration changes until the Changes – Take button
is pressed.
Ties as lines — Displays ties as lines (figure 5-15).
Figure 5-15 — Ties shown as lines
Ties as crosspoints — Displays ties as a matrix of inputs and outputs (figure 5-16).
Ties that have been made are indicated as amber (video and audio), green
(video only), and red (audio only) boxes. Ties that will take effect when you
click on the Take button are indicated by +. Ties that will be broken when you
click on the Take button are indicated by –.
Figure 5-16 — Ties shown as crosspoints
Frequency read options (CrossPoint 450 Plus only) — Allows you to set the input
signal detection (DSVP) feature as follows:
• To never sample and display the sync or no sync status
(set this option to None)
• To automatically refresh the display
(set this option to Automatically every 10 seconds)
• To sample the sync and update the display whenever you make a
configuration change (set this option to On demand or by refresh).
Limit ties to same group — Allows you to limit the creation of ties using the
program to inputs and outputs that are in the same group (similar to front
panel operation).