Extron Electronics MAV Plus Series - Manual (Page 154)

6-3 CrossPoint 450 Plus and MAV Plus Switchers • HTML Operation
b . Is there a file in the switcher’s memory that is named “index.html”?
If so
, the switcher downloads “index.html” as the default startup page.
c . If neither of the above conditions is true , the switcher downloads the
factory-installed default startup page, “nortxe_index.html” (figure 6-2),
also known as the System Status page.
System Status Page
The System Status page (figure 6-2) provides an overall view of the status of the
matrix switcher, including the primary and secondary power supply status, the
individual voltages, and the fan status (if applicable). The System Status page is
the default page that the switcher downloads when you connect to the switcher.
Access the System Status page from other pages by clicking the Status tab.
Refresh.
Select DSVP.
Figure 6-2 — System Status page
Components that are operating properly are indicated in green.
Failures are indicated in red.
Components that are not installed are indicated in gray.
The status web page automatically updates itself periodically to reflect the latest
status of the switcher components.
The CrossPoint 450 Plus and MAV Plus switchers are not available in custom
configurations. Each model has all available monitored components, such as
power supplies and fans, installed. If you see the gray “not installed”
indication, the “not installed” component probably became disconnected
during shipment or rough handling.
Smaller switchers (16 x 16 matrix sizes and smaller) do not show the power
supply and fan status blocks.
If a component fails or becomes disconnected, the display shows the change in
status the next time it updates.