Extron Electronics MAV Plus Series - Manual (Page 18)

1-7 CrossPoint 450 Plus and MAV Plus Matrix Switchers • Introduction
• MAV 3216 Plus (32 inputs by 16 outputs)
 SVA  SV
 AV  V  A
• MAV 3232 Plus (32 inputs by 32 outputs)
 SVA  SV
 AV  V  A
MAV Plus HDA and HD switchers can also route low resolution RGsB and RsGsBs
video signals. HDA and HD switchers can also route multiple composite video
planes or S-video and composite video. If used in this way, the various video
planes cannot be broken away; the input signals on the Y, R-Y, and B-Y input BNCs
must be routed to the same outputs.
MAV Plus SVA and SV switchers can also be used to switch two planes of
composite video. If used in this way, the two video planes cannot be broken away;
the input signals on the luma and chroma input BNCs must be routed to the same
outputs.
The MAV Plus Series have a bandwidth of 150 MHz (-3 dB).
Definitions
The following terms, which apply to Extron matrix switchers, are used throughout
this manual:
Tie — An input-to-output connection.
Set of ties — An input tied to two or more outputs. (An output can never be tied
to more than one input.)
Configuration — One or more ties or one or more sets of ties.
Current configuration — The configuration that is currently active in the
switcher (also called configuration 0)
Global memory preset — A configuration that has been stored. Up to 32 global
memory presets can be stored in memory. Preset locations are assigned to
the input buttons and (where necessary) output buttons. Up to 20 or 32
(depending on the number of input and output buttons) presets can be
selected from the front panel for either saving or retrieving. When a preset
is retrieved from memory, it becomes the current configuration. All models
have 32 presets; on models with fewer than 32 input and output buttons,
preset numbers that are too high to be available from the front panel are still
accessible under serial port or Ethernet control.