Extron Electronics MAV Plus Series - Manual (Page 45)

Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation 3-2
Operation
The operation of the CrossPoint 450 Plus switchers and MAV Plus switchers
is very similar. There are two exceptions:
• The video selection button is labeled “RGBHV” on the
CrossPoint 450 Plus switchers and “Video” on the MAV Plus switchers.
• The MAV Plus switchers do not offer RGB delay switching.
Front Panel Controls and Indicators
The front panel controls (figure 3-1 through figure 3-3) are grouped into two sets.
The input and output buttons are grouped on the left side of the control panel. The
control buttons and video/audio (I/O) selection buttons are grouped on the right
side of the panel.
While the number of inputs and outputs varies depending on the size of the
matrix, there are only three front panel arrangements: 12 input buttons by 8
output buttons (figure 3-1), 16 by 16 (figure 3-2), and 32 by 32 (figure 3-3).
See the table below to identify the front panel arrangements used by each
switcher model.
On smaller matrix switchers, the larger-numbered buttons are not used for
input and output selection, although they are used to select and indicate preset
numbers, indicate the input audio level, and indicate the output audio volume.
Switcher
model
Panel
32 x 32 12 x 8 Figure
CrossPoint 450 Plus
84, 88, 124, 128
MAV Plus
88, 128
CrossPoint 450 Plus
MAV Plus
816, 1212, 1616
CrossPoint 450 Plus
MAV Plus
2412, 2424, 3216, 3232
3-2
3-3
3-1
16 x 16
AUDIO VIDEO
I/O CONTROL
ENTER PRESET VIEW ESC
INPUTS
1 2 3 4 5 6 7 8 9 10 11 12
OUTPUTS
1 2 3 4 5 6 7 8
CROSSPOINT 450 PLUS SERIES
ULTRA-WIDEBAND MATRIX SWITCHER WITH ADSP™ AND IP LINK™
CONFIG
8 6 5 4 3 7
1
2
Figure 3-1 — Front panel, CrossPoint 450 Plus 128 HVA