Extron Electronics MAV Plus Series - Manual (Page 61)

Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation 3-18
Example 4: Viewing video and audio, audio only, and video only ties
In the following example, we view the video and audio, audio-only, and video-only
ties in the current configuration. The steps show the front panel indications that
result from your action.
This example assumes that you have performed example 1, example 2, and
example 3.
1 . Press and release the Esc button (figure 3-23).
C O N T R O L
PRESET ENTER ESC VIEW
Press the Esc button to clear all selections .
The button flashes once .
Figure 3-23 — Clear all selections
2 . Press and release the View button to enter View-Only mode. The View button
lights red.
3 . To select both video and audio for viewing, if necessary, press and release the
RGBHV (CrossPoint 450 Plus switchers) or Video (MAV Plus switchers)
button and the Audio button (figure 3-24).
1 2 3 4 5 6 7 8 15 16
17 18 19 20 21 22 23 24 31 32
O
U
T
P
U
T
S
I / O
VIDEO AUDIO
Until you select an input, the buttons for all untied
outputs light amber if no inputs are tied, green if
no video inputs are tied (only audio is tied), or
red if no audio inputs are tied (only video is tied).
Press the Audio button
to toggle on and off.
The button lights red
when selected.
Press the RGBHV/ Video
button to toggle on and off.
The button lights green
when selected.
Red Amber Unlit
Figure 3-24 — Select RGBHV or video and audio